Support for Fusion VCO

My Fusion VCO’s 1V/Oct input is not tracking incoming CV signals correctly, it tracks only the highest notes from the sequencer/keyboard. What should I do?

If the VCO tracks notes only above C4 or higher, please, make sure that the FREQUENCY knob is all way counter-clockwise, because this knob defines the lowest frequency you can get from the VCO.
My Fusion VCO’s 1V/Oct input is not tracking incoming CV signals correctly, it tracks only the highest notes from the sequencer/keyboard, but sounds which come from the VCO are pretty low. What should I do?

Please, make sure if your device’s output signal is unipolar (from 0V to +10V) because the Fusion VCO’s 1V/Oct input is intended to track only positive CV signals. In case your device has a bipolar output signal (from -5V to +5V), we recommend you to use the Pico MScale: the upper part of this module adds +5V offset, so the signal from sequencer, which gives values from -5V to +5V for 1V/Oct, transforms into a signal which is compatible to the Fusion VCO.